Always measure from the center/heart of the rail, not from the outside edge.The drawing is a top view, viewed from above.The little figure with the dotted lines shows from which side you are looking at the rail, meaning the visible side.

We can bend the rail based on a template if required.Bending based on a template is possible, depending on feasibility. If it cannot be carried out, we will contact you to discuss an alternative. If it is necessary to create a CAD drawing of the rail based on limited information, additional costs may be charged depending on the situation.

Bending • Qurails

Bending options

for curtain rails

Find information here about all the possible options for bends.

Drawing 1

90° return bend, right

Drawing 2

90° return bend, left

Drawing 3

90° bend, right

Drawing 4

90° bend, left

Drawing 8

135° return bend, right

Drawing 9

135° return bend, left

Drawing 10

135° bend, left

Drawing 11

135° bend, right

Drawing 19

Half circle

Drawing 20

Quarter circle

Drawing 5

90° bends, left and right

Drawing 6

90° return bends, left and right

Drawing 7

135° bends, left and right

Drawing 14

135° return bends, left and right

Drawing 15

135° bend, left and 135° return bend, right

Drawing 16

135° return bend, left and 135° bend, right

Drawing 17

90° bend, left and 90° return bend, right

Drawing 18

90° return bend, left and 90° bend, right

Special Drawing 22

Applies when the desired situation is not listed. The drawing is always assessed for feasibility beforehand.

If the angle differs from 90° or 135°, it is also considered a special drawing.

Drawing 23

90° return bend, left, 90° bend, 90° return bend, right

Drawing 24*

90° return bend, left, 90° bend, 90° return bend, right

Drawing 25*

135° return bend, left, 135° bend, 90° return bend, right

Drawing 26

90° return bend, left, 135° bend, 135° return bend, right

Special Drawing 22

Applies when the desired situation is not listed. The drawing is always assessed for feasibility beforehand.

If the angle differs from 90° or 135°, it is also considered a special drawing.

* only possible with electric and cord-operated rails.

Drawing 12

2x 135° bends, left and 2x 135° bends, right

Drawing 13

2x 90° bends, left and 2x 90° bends, right

Drawing 27

2x 135° bends, left and 2x 135° bend, right

Special Drawing 22

Applies when the desired situation is not listed. The drawing is always assessed for feasibility beforehand.

If the angle differs from 90° or 135°, it is also considered a special drawing.

Let op: bij elektrisch bediende systemen is de maximale bocht 180°.

Additional information

How do we measure?

Always measure from the center/heart of the rail, not from the outside edge.
The drawing is a top view, viewed from above.
The little figure with the dotted lines shows from which side you are looking at the rail, meaning the visible side.

Which measurement should you provide?

Provide the measurement including any end caps or pulleys. We call this the system size.

Clearance around the rail

For manually operated rails, keep 0.5 cm clearance from the wall.
For electric rails, allow an extra 1.5 cm on the motor side and 0.5 cm on the other side.

Production and finish

The welded joint is placed in the centre of the rail as standard, unless stated otherwise.

Custom-made options

We can bend the rail based on a template if required.
Bending based on a template is possible, depending on feasibility. If it cannot be carried out, we will contact you to discuss an alternative.
If it is necessary to create a CAD drawing of the rail based on limited information, additional costs may be charged depending on the situation.